Topics Topics Help/Instructions Help Edit Profile Profile Member List Register  
Search Last 1 | 3 | 7 Days Search Search Tree View Tree View  
Route 6x6 Discussion Board * Shop Talk: Tech Tips and Q&A section * Replacing PUG UTV drive belt. < Previous Next >

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Steve Travis
New member
Username: Pug_steve

Post Number: 1
Registered: 10-2011

Rating: N/A
Votes: 0 (Vote!)

Posted on Sunday, October 23, 2011 - 12:59 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only) Ban Poster IP (Moderator/Admin only)
Does anyone know how to replace the drive belt on a 70's era 4WD PUG utv? I was able to get the old one off which was quite worn but can't get the new one on around the front pulley. There just doesn't seem to be enough space between the frame and the pulley.  I am also looking for a PUG manual? I've been looking and have only found one for the two wheel drive utv.
I'm stuck until I get the drive belt installed. Any insights would be appreciated
Top of pagePrevious messageNext messageBottom of page Link to this message

Scott Leslie
New member
Username: A1shiva

Post Number: 1
Registered: 11-2011

Rating: N/A
Votes: 0 (Vote!)

Posted on Sunday, November 27, 2011 - 08:41 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only) Ban Poster IP (Moderator/Admin only)
Loosen the bolts holding the transaxle to the frame and pry the transaxle over. Do not pry on the belt pully as you will bend it. I bought one once that had the frame notched but looked weak to me

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Action: