| Author |
Message |
    
Joe J
Intermediate Member
Username: Jjconst07
Post Number: 53
Registered: 12-2007
Rating: N/A
Votes: 0 (Vote!) | | Posted on Monday, September 13, 2010 - 08:45 pm: | 
|
Hello
It has been awhile since I posted here but I have a question.
I have an argo 6wheeler, and I notice that the two center chains right and left side are getting a little loose, I can see the adjustment or chain tightner thing ( I figure its the piece the chain rides on that has a spring )and I am wondering if you could explain to me how to do it correctly, or point me towards a thread that explains it? Deer hunting is coming, have to make sure shes all ready to go.
Thank You
Joe |
Erich Kelter
Advanced Member
Username: Fisherman
Post Number: 155
Registered: 11-2005
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, October 07, 2010 - 08:43 pm: |
|
Sorry this may be too late, but, here goes. If there are grooves cut into the teflon tensioner blocks deeper than 1/4", they are supposed to be replaced. Easy enough to replace, rotate the tensioner below the blocks and hold it in position with a pair of vise grips. Pry the slider block off with a pair of pliers. Use a small block of wood to tap in the new slider block, release the vise grips and simply pull up a bit. If the slider blocks are reasonably good, just pull up on the assembly and make sure the little notched teeth on the side plates will lock into the next spot. |
|
Shop Talk: Tech Tips and Q&A section