| Author |
Message |
    
Tom Reilley
New member
Username: Blue1969camaro
Post Number: 1
Registered: 02-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Wednesday, February 17, 2010 - 06:43 pm: | 
|
Hi, i have an attex st/295 and i put a rotax 340 twin out of a ski doo tnt but the belt i have is too wide for the clutch on my transmission i measured the belt and it is 1 1/4" wide and the trans clutch is only about 5/8" wide is there a problem with my trans clutch or do i need a special narrower belt. Thanks |
Jeff bar
Advanced Member
Username: Argo8x8
Post Number: 188
Registered: 03-2005
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, February 18, 2010 - 08:39 am: |
|
What trans is in the attex?
Jeff Bar |
Tom Reilley
New member
Username: Blue1969camaro
Post Number: 3
Registered: 02-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Thursday, February 18, 2010 - 01:07 pm: |
|
its a baker hill |
Kevin Percy
New member
Username: Kevin_percy
Post Number: 1
Registered: 02-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Saturday, February 20, 2010 - 09:08 am: |
|
Tom,
Where are you measuring the width of the trans (secondary) clutch ? Out at the rim or down near the shaft ?
There are some general system tips here
http://www.gates.com/search/index.cfm?location_id=510&go=SearchGates |
Jeff bar
Advanced Member
Username: Argo8x8
Post Number: 190
Registered: 03-2005
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, February 21, 2010 - 07:54 am: |
|
Tom Richards relics has you belt
Jeff Bar |
Tom Reilley
New member
Username: Blue1969camaro
Post Number: 4
Registered: 02-2010
Rating: N/A
Votes: 0 (Vote!) | | Posted on Sunday, February 21, 2010 - 06:54 pm: |
|
Ok so i used a regular snowmobile belt that was the length i needed and used my bench grinder to sand down the edges till the belt fit in the clutch level with the top. Its not the best way i know but it will work for now. |
Shop Talk: Tech Tips and Q&A section