Topics Topics Help/Instructions Help Edit Profile Profile Member List Register  
Search Last 1 | 3 | 7 Days Search Search Tree View Tree View  
Route 6x6 Discussion Board * Shop Talk: Tech Tips and Q&A section * 500 super chief won't start after replacing starter < Previous Next >

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Jim Fletcher
New member
Username: 500superchief__jim

Post Number: 1
Registered: 06-2006
Posted From: 12.39.67.171

Rating: N/A
Votes: 0 (Vote!)

Posted on Friday, June 23, 2006 - 09:43 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only) Ban Poster IP (Moderator/Admin only)

Can someone help me with the wiring of my 1976 superchief? Ran great until I got starter hot trying to start it. Replaced starter with a new one from Richard. Now it has spark but won't start. Has good compression. Can anyone help?
Top of pagePrevious messageNext messageBottom of page Link to this message

liflod
Intermediate Member
Username: Liflod

Post Number: 85
Registered: 01-2005
Posted From: 151.201.211.103

Rating: N/A
Votes: 0 (Vote!)

Posted on Friday, June 23, 2006 - 10:14 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only) Ban Poster IP (Moderator/Admin only)

Sounds like it wasn't running too great if you got the starter hot trying to start it.
Are the plugs wet or dry ? If they're dry,
spray fuel into the carb and see if it will run. Sometimes you just need the engine running to get the fuel pump to kick in and keep it running. If it runs with the sparyed fuel and then dies, you either have fuel supply problems or carb problems. You could pull the bowl off the carb and see if theres water or crud in the bottom.
Top of pagePrevious messageNext messageBottom of page Link to this message

Charlie Richmond
Junior Member
Username: Csrichmond

Post Number: 13
Registered: 02-2005
Posted From: 206.66.249.2

Rating: N/A
Votes: 0 (Vote!)

Posted on Friday, June 23, 2006 - 02:09 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only) Ban Poster IP (Moderator/Admin only)

Give the carb a good shot of WD40.
If it starts, then you know you've got fuel problems.
If it still doesn't start then you've got electrical problems.
This test works with any type spark ignition engine.
Top of pagePrevious messageNext messageBottom of page Link to this message

david berger
Senior Member
Username: Davidrrrd

Post Number: 395
Registered: 01-2005
Posted From: 72.72.67.197

Rating: N/A
Votes: 0 (Vote!)

Posted on Friday, June 23, 2006 - 02:25 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only) Ban Poster IP (Moderator/Admin only)

how long ago did you fail to start it ant burn out starter moter, gas oil mix can evaporate leaving oil in cranck case, then your incoming only adds to whats there, too rich is no fire!
some blockds have a means to drain crank case others do not, worse yet many makes n models get water in the system so easy you wouldent beleave it.
try the fule test,
with your gasoline to carb shut off
maybe with ether first,
cause it might dry oil, old fuel and even water out of case somewhat,
then if it burps on that or runs some try wd-40 and ether combo,
im a beleaver in ether but it dose need some sort of oil right,
if this stuff fired it up switch back to fuel,
now if your fuel kills it it is your gass, might be contaminated with water or something
or your carbs screwed up,
Top of pagePrevious messageNext messageBottom of page Link to this message

Eddie Beddingfield (Unregistered Guest)
Unregistered guest
Posted From: 207.117.33.134

Rating: N/A
Votes: 0 (Vote!)

Posted on Friday, June 23, 2006 - 03:56 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only) Ban Poster IP (Moderator/Admin only)

If you have wet fouled the plugs try another set. I have dried plugs and still got no fire ,but changed to a new set and it started right up. Eddie

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Action: