Topics Topics Help/Instructions Help Edit Profile Profile Member List Register  
Search Last 1 | 3 | 7 Days Search Search Tree View Tree View  
Route 6x6 Discussion Board * Shop Talk: Tech Tips and Q&A section * Bearings froze up on the axle < Previous Next >

  Thread Last Poster Posts Pages Last Post
Archive through September 11, 2000MaxRules22 1 02-23-05  10:35 pm
  ClosedClosed: New threads not accepted on this page        

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

RL King

Rating: N/A
Votes: 0 (Vote!)

Posted on Wednesday, February 23, 2005 - 10:40 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only) Ban Poster IP (Moderator/Admin only)
To remove a inner shaft bearing on a 1998 MAX IV, you need to use a small screw jack like the ones used on an older Toyota truck. Remove the control rods so that the channel down the center of the frame is empty. Lay the jack on it's side and place a socket between the jack head and the end of the axle you are removing and turn the jack's screw until it makes contact with the axle end. Now just screw the jack and watch the axle be pushed out. Using this method, you should not damage the bearing.

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Action: