| Author |
Message |
    
steven caldwell (Pisgah001)
Rating: N/A
Votes: 0 (Vote!) | | Posted on Wednesday, February 23, 2005 - 10:34 pm: | 
|
My current bearings on my Max II are of BCA Vanguard series (vanguard refers to the type of seal). The number on the bearings is 'W 103-2' and also what appears to be a '2-EOIM' on one of the rims.
I am looking to replace them but cannot find the exact number on the internet so I am assuming the number has changed somewhere along the line.
I have taken some measurements and done some poking around and found that bearings having the number NPS-103-RP2C seem to be the ones I want.
Can someone verify this? Anyone use these on their MAX II? |
Fred Sowerwine, Montana's Max Dealer (Fred4dot)
Rating: N/A
Votes: 0 (Vote!) | | Posted on Wednesday, February 23, 2005 - 10:34 pm: |
|
Steven, The replacement bearings I have are: BCA bearing #WPS103GR2ANC. On the other thread, the belt number is right (current number is 15252AA) not sure on length, but width appears to be 3/16 inch. Book says to replace it when it is 1/16 wide. If you will use belt dressing (I use liquid stuff and put it on both edges with my finger) you will have increased belt life and excellent performance. |
david berger (Davidrrrd)
Rating: N/A
Votes: 0 (Vote!) | | Posted on Wednesday, February 23, 2005 - 10:34 pm: |
|
thers alot of them out there, i have here in my hand a FAFNIR RA103RRB2
IT FITS MY 86 MAX II,AND THERE INEXPENCIVE |
steven caldwell (Pisgah001)
Rating: N/A
Votes: 0 (Vote!) | | Posted on Wednesday, February 23, 2005 - 10:34 pm: |
|
After double checking, the ones listed above have a narrow collar....I need any of the following
BCA WPS103GR2C (R means it has a relube hole)
FAFNIR G1103GR2C (1st G means it has a relube hole)
BCA WPS103GP2c (P is for permanent lube)
1103KRRB2 (No leading G means no relube hole)
Not sure if the last one is correct, but anyone have a URL where I can get these online. |
Shop Talk: Tech Tips and Q&A section