My lights are dim
Route 6x6 Discussion Board: Shop Talk: Tech Tips and Q&A section: My lights are dim
Top of pagePrevious messageNext messageBottom of pageLink to this message   By Glen H. on Unrecorded Date: Edit

I have a Lockley 295. The engine has been changed to a 395cc pull start suziki snowmobile engine. When I put my trouble light on hot wire its bright but when I hook up the lights it dims right down. I think I have sufficient ground. Any suggestions.

Top of pagePrevious messageNext messageBottom of pageLink to this message   By liflod (Liflod) on Unrecorded Date: Edit

It sounds like you either have too much draw on the system (wrong headlights) or you have a defective rectifier. You may have a bad fuse in the rectifier. Some of the older ones have a fuse compartment built into the rectifer. Also check for other bad conections in the system. Try one headlight at a time and see if that helps.

Add a Message


This is a public posting area. If you do not have an account, enter your full name into the "Username" box and leave the "Password" box empty. Your e-mail address is optional.
Username:  
Password:
E-mail:

Administrator's Control Panel -- Board Moderators Only
Administer Page | Delete Conversation | Close Conversation | Move Conversation