Archive through August 22, 2001

Route 6x6 Discussion Board: Shop Talk: Tech Tips and Q&A section: ARGO engine replacement: Archive through August 22, 2001
Top of pagePrevious messageNext messageBottom of pageLink to this message   By PJ White on Unrecorded Date: Edit

I have a 1980 ARGO 6x6 with a 16 HP Tec I am thinging of replacing it with a twin cyl does anyone have any recomendations on what type of motor would best suite it I was thinking HONDA 20HP?

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Douglas MacCullagh (Dougmac) on Unrecorded Date: Edit

PJ -

I have a new Argo 8x8 with the 18 HP Briggs Vanguard. Good engine!! The only concern I'd have with increasing the power in your machine is the brakes heating up too much. You might want to add a brake cooling fan (or 2) as part of the upgrade?

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Gord Young on Unrecorded Date: Edit

PJ,

You might want to stay with the tried and proven. The Vanguard engines are very reliable and are easier to find support for when it cmes to parts and service.

Take a look at the torque curves of the Honda and the Briggs engines. I think you'll be surprised when you find that the Briggs torque curve is relatively flat and the engine develops most of its torque at low RPM ranges. The Honda by comparison makes its torque at much higher revs. This makes one engine more drivable in the deep woods than the other.

When it comes to mounting the driver clutch to the Briggs, Argo has already done the work. The Honda could be done with a little machine too of course.

Perhaps the most important consideration is heat dissipation. The Briggs and the honda are both air cooled engines. Argo sells ducting for the Briggs to keep the body from melting!! The honda would require fabrication of something similar. Again a little more engineering would be required.

I'm not a Briggs salesman by the way but I do have a little experience with Briggs and have found the Vanguard engines to be very good engines for a 6x6.

I hope this info helps!

Gord

Top of pagePrevious messageNext messageBottom of pageLink to this message   By Sam Keys on Unrecorded Date: Edit

PJ

I did consider that conversion. I stayed with the TEC
engine because when ARGO installed the VANGUARD they
also redesigned the upper body for more space. (they raised
the whole top 3" , check out the way a vanguard argo body looks
in the front) I just rebuilt the TEC oh160, runs well and believe
it or not it WILL out pull a 16hp VANGUARD.

I hope this statement does not start a war

Sam Keys

Top of pagePrevious messageNext messageBottom of pageLink to this message   By david berger (Davidrrrd) on Unrecorded Date: Edit

pj,also the vangard has problems no mater who's type of vehicle it's in, the fule system is alwase problematic for them,and who needs a govener anyway?

Administrator's Control Panel -- Board Moderators Only
Administer Page | Delete Conversation | Close Conversation | Move Conversation